cxd56_gpioif.h File Reference

#include <nuttx/config.h>
#include <stdint.h>
#include <stdbool.h>
#include <nuttx/irq.h>

Go to the source code of this file.

Macros
#define	EXTERN   extern "C"
Pin Pull Setting
Pin floating, pull up, pull down definitions
#define	PIN_FLOAT   (0) /* Floating */
#define	PIN_PULLUP   (1) /* Internal Weak Pull Up */
#define	PIN_PULLDOWN   (2) /* Internal Weak Pull Down */
#define	PIN_BUSKEEPER   (3) /* Internal Bus-Keeper */

GPIO Interrupt Setting
GPIO interrupt level and edge trigger types
#define	INT_HIGH_LEVEL   (2) /* High Level */
#define	INT_LOW_LEVEL   (3) /* Low Level */
#define	INT_RISING_EDGE   (4) /* Rising Edge */
#define	INT_FALLING_EDGE   (5) /* Falling Edge */
#define	INT_BOTH_EDGE   (7) /* Both Edge */
int	board_gpio_config (uint32_t pin, int mode, bool input, bool drive, int pull)
int	board_gpio_status (uint32_t pin, bool *input, bool *output, bool *drive, int *pull)
void	board_gpio_write (uint32_t pin, int value)
int	board_gpio_read (uint32_t pin)
int	board_gpio_intconfig (uint32_t pin, int mode, bool filter, xcpt_t isr)
int	board_gpio_intstatus (uint32_t pin, int *mode, bool *filter, bool *enabled)
int	board_gpio_int (uint32_t pin, bool enable)